I don't know about the TNTs, but with the Max 40xx units, you have to set
"shared profiles"=yes. That tells the Max to let radius override settings
in the Max (if there are radius settings sent through after authentication,
etc.) If your problem is related to the "shared profiles" setting (if it
even exists in a TNT), I don't know where it is. In the 40xx units, it's in
Ethernet --> Mod Config --> Shared Prof
Also, make sure you're using the correct radius attribute. I don't know if
the TNTs use the same info as the 40xx units do, but at least with the Max
40xx, you use "Ascend-Idle-Limit" to set the session timeout value (measured
in seconds). The "Ascend-Maximum-Time" is used to set a maximum session
duration (again, in seconds). The Ascend-Disconnect-Cause associated with
both of these is "100".
Josh
For more information about this list (including removal) go to:
http://www.iea-software.com/support/maillists/liststart