This Message was undeliverable due to the following reason:
The following destination addresses were unknown (please check
the addresses and re-mail the message):
SMTP <macmilan@yebo.co.za>
Please reply to Postmaster@neptune.yebo.co.za
if you feel this message to be in error.
--===========================_ _= 5469665(25263)
Content-Type: message/rfc822
Received: from relay01.iafrica.com ([196.7.0.160]) by neptune.yebo.co.za
(Post.Office MTA Undefined release Undefined
ID# 0-54426U40000L40000S0V35) with ESMTP id AAA21338
for <macmilan@yebo.co.za> Thu, 15 Oct 1998 19:52:37 +0200
Received: from [207.53.165.8] (helo=walnut.iea-software.com)
by relay01.iafrica.com with esmtp (Exim 1.92 #2)
for macmilan@sprintlink.co.za
id 0zTrZ9-0000YD-00; Thu, 15 Oct 1998 19:52:00 +0200
Received: from walnut.iea-software.com (walnut.iea-software.com [207.53.165.8]) by walnut.iea-software.com (NTMail 4.00.0020/NT6651.00.c89adb95) with ESMTP id za002374 for <emerald@iea-software.com> Thu, 15 Oct 1998 10:40:28 -0700
Received: from [206.85.21.2] by walnut.iea-software.com (NTMail 4.00.0020/NT6651.00.c89adb95) with ESMTP id filbaaaa for <emerald@iea-software.com> Thu, 15 Oct 1998 10:40:26 -0700
Date: Thu, 15 Oct 1998 12:47:33 CDT
Message-Id: <199810151247.AA1977287212@rwts.qcom.net>
Mime-Version: 1.0
Content-Type: text/plain; charset=us-ascii
From: "MailingList Receiver" <list_rx@qcom.net>
Reply-To: <list_rx@qcom.net>
X-Sender: <list_rx@rwts.qcom.net>
To: emerald@iea-software.com
Subject: setting up a dialback user thru Emerald
X-Mailer: <IMail v4.06>
X-DomainScript: iea-software.com\\script.mml
X-Script: \\FilterScript.mml
X-UserScript: iea-software.com\emerald\script.mml
RadiusNT 2.5, Emerald, PM-3 -
I have a user that we will be setting up with ISDN service that we will need to dialback to avoid toll charges.
The customer will be running a 3com router with NAT.
They will need to dial-up, authenticate into our system then have the PM-3 drop them, dial them back and make the permanent connection.
Is this possible and what lines in the SA record need to be set? I am also assuming there will need to be a location set into the PM-3..
Reply to the list please as I didn't find anything in the archive for this -
Thanks
list_rx@qcom.net
--===========================_ _= 5469665(25263)--