> -----Original Message-----
> From: emerald-request@iea-software.com
> [mailto:emerald-request@iea-software.com]On Behalf Of Tom Bilan
> Sent: Friday, February 12, 1999 8:30 AM
> To: 'emerald@iea-software.com'
> Subject: RE: [Emerald] HyperARC and RadiusNT
>
>
> It's a problem with the HiperARC. Their port numbering is retarded.
>
> I complained to USR a year ago about this and they added the commands:
> SET PBUS REPORTED_BASE
> SET PBUS REPORTED_PORT_DENSITY
>
> USR/3com defaults to 256 per port and if you are running
> hiper DSPs you need
> to change that to 24. If you're running quad modem cards
> it's 4. If you
> have both HiperDSPs and Quads in the same chassis they you
> need to set it to
> 24 (the highest of the two).
>
> Tom Bilan
> TDI Internet
>
> -----Original Message-----
> From: Billy Huddleston [mailto:billy@nxs.net]
> Sent: Thursday, February 11, 1999 8:41 PM
> To: emerald@iea-software.com
> Subject: [Emerald] HyperARC and RadiusNT
>
>
> Just upgraded from a Total Control NetSever to a HyperARC
> with HyperDSP
> cards and Quad Modem cards.
> I've been resarching the archives and find that lots of
> people have been
> having problems with
> the way 3Com does the port numbering. Has anyone figured this
> out? My first
> 23 modems are
> showing up in my online calls okay, but as far as I can tell,
> the second
> card is about 1000
> ports above the first one. Anyone have any ideas? Also, How
> are you suppose
> to configure the
> accounting and radius setup in the TC? I've got it using
> Ascend for the
> "radius type" and
> have Enable Hint Assigned and Enable AcctG checked, (didn't
> check the Enable
> Acct Interval)
>
> Thanks, Billy Huddleston
>
>
>
>
> For more information about this list, including removal,
> please see http://www.iea-software.com/maillist.html
>
> For more information about this list, including removal,
> please see http://www.iea-software.com/maillist.html
>
For more information about this list, including removal,
please see http://www.iea-software.com/maillist.html