phil@cloh.net
-----Original Message-----
From: Billy Huddleston <billy@nxs.net>
To: emerald@iea-software.com <emerald@iea-software.com>
Date: Friday, February 12, 1999 12:06 PM
Subject: RE: [Emerald] HyperARC and RadiusNT
>I did these commands. However, it still seams that only the first HyperDSP
>will show up on
>the connection list, anyone on the second card doesn't show up, and from
>what I can tell,
>the TC is using something around 1000+ for the NAS address for ports on the
>second card.
>
>
>> -----Original Message-----
>> From: emerald-request@iea-software.com
>> [mailto:emerald-request@iea-software.com]On Behalf Of Tom Bilan
>> Sent: Friday, February 12, 1999 8:30 AM
>> To: 'emerald@iea-software.com'
>> Subject: RE: [Emerald] HyperARC and RadiusNT
>>
>>
>> It's a problem with the HiperARC. Their port numbering is retarded.
>>
>> I complained to USR a year ago about this and they added the commands:
>> SET PBUS REPORTED_BASE
>> SET PBUS REPORTED_PORT_DENSITY
>>
>> USR/3com defaults to 256 per port and if you are running
>> hiper DSPs you need
>> to change that to 24. If you're running quad modem cards
>> it's 4. If you
>> have both HiperDSPs and Quads in the same chassis they you
>> need to set it to
>> 24 (the highest of the two).
>>
>> Tom Bilan
>> TDI Internet
>>
>> -----Original Message-----
>> From: Billy Huddleston [mailto:billy@nxs.net]
>> Sent: Thursday, February 11, 1999 8:41 PM
>> To: emerald@iea-software.com
>> Subject: [Emerald] HyperARC and RadiusNT
>>
>>
>> Just upgraded from a Total Control NetSever to a HyperARC
>> with HyperDSP
>> cards and Quad Modem cards.
>> I've been resarching the archives and find that lots of
>> people have been
>> having problems with
>> the way 3Com does the port numbering. Has anyone figured this
>> out? My first
>> 23 modems are
>> showing up in my online calls okay, but as far as I can tell,
>> the second
>> card is about 1000
>> ports above the first one. Anyone have any ideas? Also, How
>> are you suppose
>> to configure the
>> accounting and radius setup in the TC? I've got it using
>> Ascend for the
>> "radius type" and
>> have Enable Hint Assigned and Enable AcctG checked, (didn't
>> check the Enable
>> Acct Interval)
>>
>> Thanks, Billy Huddleston
>>
>>
>>
>>
>> For more information about this list, including removal,
>> please see http://www.iea-software.com/maillist.html
>>
>> For more information about this list, including removal,
>> please see http://www.iea-software.com/maillist.html
>>
>
>
>For more information about this list, including removal,
>please see http://www.iea-software.com/maillist.html
For more information about this list, including removal,
please see http://www.iea-software.com/maillist.html