pbus base at 1
pbus reported_port_density 24
First HyperDSP will be 0-22 (total of 23 for PRI)
Second HyperDSP and anything that follows uses this formula
1000 + ( port_density[24] * (slot -1) ) + ( modem_number -1 )
So, Lets say we're calculating slot 2, modem 4
1000 + ( 24 * (2 - 1) + ( 4 - 1) ) = 1027
Needless to say, anyone with a brain knows this is the stupidest thing
they've
ever seen. :) I would say that 3com will probably change this in a newer
code
release.
Thanks, Billy Huddleston
> -----Original Message-----
> From: emerald-request@iea-software.com
> [mailto:emerald-request@iea-software.com]On Behalf Of Dale E. Reed Jr.
> Sent: Friday, February 12, 1999 2:00 PM
> To: emerald@iea-software.com
> Subject: Re: [Emerald] HyperARC and RadiusNT
>
>
>
>
> Billy Huddleston wrote:
> >
> > I did these commands. However, it still seams that only the
> first HyperDSP
> > will show up on
> > the connection list, anyone on the second card doesn't show
> up, and from
> > what I can tell,
> > the TC is using something around 1000+ for the NAS address
> for ports on the
> > second card.
>
> Go into the Emerald Admin and add each port that it is
> including in the
> Accounting requests. That should allow those ports to show up.
>
> --
> Dale E. Reed Jr. (daler@iea-software.com)
> _________________________________________________________________
> IEA Software, Inc. | RadiusNT, Emerald, and NT FAQs
> Internet Solutions for Today | http://www.iea-software.com
>
> For more information about this list, including removal,
> please see http://www.iea-software.com/maillist.html
>
For more information about this list, including removal,
please see http://www.iea-software.com/maillist.html